Over 2000 Products

Quantity Discounts

k.pietrusa@allbag.pl

5% Discount

For First Order

ALLBAGWITA

What to do when your solar lamp stops working? We give you a hint!

Co zrobić, gdy lampa solarna przestała działać? Podpowiadamy!

Adrian Koźlik |

Solar lamps are not only aesthetic garden lighting, but also an ecological and economical way to use solar energy. However, like any device, they may sometimes fail. If your solar lamp stops shining, you don't have to buy a new one right away. We have prepared a practical guide for you on how to repair a faulty solar lamp step by step.

Charging the battery - the first step to repair

solar lamp The most common reason why a solar lamp stops shining is that the battery is not charged enough. Solar batteries collect energy from sunlight and store it to later be used to power a lamp . If the battery is low, the lamp it won't have enough power to shine.

At the start, we must check whether the solar lamp has been exposed to sufficient sunlight for an appropriate amount of time. Typically, solar lights require approximately 6 hours of solar panel charging for the battery to be fully charged. If the lamp was shaded or exposed to light for a short time, the battery may not have charged sufficiently.

If you are sure the lamp has had sufficient charge time, check the battery status. It may be necessary to replace it with a new one. Make sure you choose a battery with the correct specifications compatible with your solar lamp to ensure proper operation.

The next step in repairing a faulty solar lamp is to check the settings and sensors. Some solar lights have different operating modes that can be set using switches. Make sure the lamp is set to the appropriate mode, such as auto mode or motion sensor mode. If the lamp is set to a mode that does not correspond to the current situation, it may result in no light.

Also check motion sensors. Motion sensors are responsible for turning on the lamp when they detect movement nearby. If the sensor is damaged or blocked, it may prevent the solar light from working properly. Check that the sensor is clean and free of any obstructions. If it is damaged, it may need to be replaced.

The next step in repairing a faulty solar light is to check the solar panel and wiring. Make sure the solar panel is clean and free from any debris such as leaves, dust or dirt. Dirt can block sunlight and prevent the panel from charging the battery properly.

Also check the wires connected to the solar lamp. Making sure the cables are connected securely and there is no damage to them. If the cables are damaged, they must be repaired or replaced. You can do it yourself using electrical tape or solder.

Mechanical damage and manufacturing errors

If none of the above solutions helped repair the solar lamp , it is possible that the lamp has suffered mechanical damage or has manufacturing defects. Check for any visible damage to the lamp, such as cracks, loose components, or damaged casings. If so, you may need to contact the lamp manufacturer for further guidance or a product replacement.

If the solar lamp is defective due to manufacturing errors, we recommend contacting the lamp manufacturer. Where the lamp is still under warranty, the manufacturer may offer to repair or replace the lamp with a new one.

Before there is light

Repairing a faulty solar lamp can be done with a few simple steps. First, check the battery charge and make sure the lamp has had adequate charge time. Then check the settings and sensors to make sure the lamp is set and working properly. Also check the solar panel and wiring to make sure they are in good condition. If none of these solutions help, it is possible that the lamp has mechanical damage or manufacturing errors, in which case contact the lamp manufacturer. Keep in mind that repairing a solar lamp may require some technical skills, so it's worth consulting a professional if you're not sure how to repair a solar lamp yourself.

Leave a comment